Diode LED DI-0161 BLAZE 9.5ft Cool White 5000k 5050 SMD LED High Performance Waterproof LED Strips
BLAZE Wet Location High Output Strip Light has twice as many LED chips as the FLUID VIEW Strip Light, so it offers twice the brightness. It has the same ultra-low profile as the FLUID VIEW strips, which means it will fit in almost any lighting installation. This flat strip is only a quarter inch high by a third of an inch wide, so it can be installed in many small or difficult locations, whether indoors or outdoors.
Although BLAZE Wet Location High Output Strip Lights are twice as bright as standard strips, they use a mere 2.9 Watts of electricity per foot! This strip features LED lights that, unlike halogen fixtures, emit very little heat. The energy efficiency, flexible design, and high intensity of LED strip lighting make it optimal for these home and commercial lighting situations:
- Kitchen cabinet, under cabinet, shelf, and case lighting
- Exhibit, presentation, and project lighting
- Decks, porches, patios, gardens, trellises, gazebos, and steps
- Task, cove, and interior accent lighting
- Shop windows, window displays, display case lights, and uplighting
- Light boxes and interior signage
- Spool Length: 9.5 ft.
- Width: 0.4 in.
- Height: 0.1 in.
- LEDs per foot: 36
- LED Spacing: 0.3 in. (between centers)
- Field Cuttable: every 3 LEDs / 1 in.
- Connectors: 4 inch waterproof plug on each end
- LED Bulb Type: 5050 SMD LED
- Beam Angle: 120°
- IP Rating: IP68
- Input Voltage: 12V DC
- Power Consumption per ft.: 2.9W / 242mA
- Color: Cool White
- Color Temp.: 5000k
- Lumens per ft.: 240
- Fixture Surface Temp.: 68° - 104° F
- UV/IR Radiation: None
- Lifespan: 50,000 hours
Each 19 foot section (two 9.5 foot spools) needs to be separately wired to the power supply to avoid voltage drop.
9 clips, 18 screws, 5 end caps, and 1 Waterproof Solder Connector Pair are included with each spool.
Each spool comes with a pair of Waterproof Solder Connectors to connect the strip to a 12V Hard-Wired Driver. The BLAZE Wet Location High Output Strip Light can also be powered by any of our 12V Hard-Wired Dimmable Drivers which connect to household wiring and a 120V AC dimmer. This strip light is installed by simply mounting it where you wish with the 9 clips, 18 screws, 5 end caps, and 1 Waterproof Solder Connector Pair that are included with each spool.
Not recommended as submersible or for use in or around treated, chlorinated or salt water.
|Beam Angle (deg.)||120|
|Color Temperature (K)||5000K|
|Color Rendering Index (CRI)||80|
|Luminous Flux (LM)||2280|
|Number of LEDs||342|
|LED Chip Size||5050 SMD|
|Cable Type||Silicone Cover|
|Power Consumption||2.9w / ft|
|Rated Life (Hours)||50000|
|Voltages (V)||12V DC|